MacDon M155 Unloading And Assembly Instructions page 182

4. Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
6. Press SELECT (D) until KNIFE SPEED is displayed on
the upper line.
•
ENABLED/LOCKED is displayed on the lower line.
7. Press left arrow (B) to enable KNIFE SPEED control
switch, or press right arrow (C) to lock KNIFE SPEED
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.52: M155 Control Locks Shown – M205
Similar
Figure 4.53: M155 Knife Speed Control Lock
Shown – M205 Similar
170
Revision A