5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
•
ACTIVATE HEADER HT is displayed on the
upper line.
7. Press SELECT (E) until ACTIVATE DWA DRV is
displayed on the upper line.
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Do NOT overspeed the DWA drive.
Press and hold HAZARD (C) button.
•
Press left arrow (B) to decrease DWA drive speed.
•
Press right arrow (D) to increase DWA drive speed.
IMPORTANT:
Verify the DWA drive is functioning properly.
8. Release the HAZARD (C) button. The DWA drive
will stop.
9. Press PROGRAM (A) to exit Programming Mode or
press SELECT (E) to proceed to next ACTIVATE
FUNCTION.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.135: M155 Functions Shown – M205
Similar
Figure 4.136: M155 DWA Drive Shown – M205
Similar
209
Revision A