Testing Reel Up/Down Activate Function Using Cab Display Module - MacDon M155E4 Assembly Instruction Manual

5. Press SELECT (B) until ACTIVATE FUNCTIONS? appears on
the upper line.
• NO/YES will appear on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
7. Press SELECT (D) until ACTIVATE HEADER HT appears on the
upper line.
• DOWN/UP will appear on the lower line.
8. Press and hold left arrow (B) to lower the header, or press
and hold right arrow (C) to raise the header. Ensure that the
header is working properly.
9. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next header function option.

5.9.2 Testing Reel Up/Down Activate Function Using Cab Display Module

The cab display module (CDM) can be used to change the height of the attached header's reel, rather than using the reel
height controls on the ground speed lever (GSL). Perform a test to ensure this feature is functioning properly.
NOTE:
• This procedure applies to windrowers with attached draper headers only.
• The header must be attached to the windrower to perform this procedure. The CDM automatically adjusts its
programming for each header.
DANGER
Ensure that all bystanders have cleared the area.
215794
CAB DISPLAY MODULE
Figure 5.117: Functions
A
B
Figure 5.118: Header Height
111
ACTIVATE FUNCTIONS?
CXXX
EXXX
NO/YES
ACTIVATE HEADER HT
CXXX
EXXX
DOWN/UP
B
A
D
C
Revision A