4. Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
6. Press SELECT (D) until HEADER FLOAT is displayed
on the upper line.
•
ENABLED/LOCKED is displayed on the lower line.
7. Press left arrow (B) to enable HEADER FLOAT control
switch, or press right arrow (C) to lock HEADER FLOAT
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
214298
CAB DISPLAY MODULE (CDM)
Figure 4.40: M155 Control Locks Shown – M205
Similar
Figure 4.41: M155 Header Float Control Lock
Shown – M205 Similar
164
Revision A