6. Position the wheels against the hubs so the air
valves (A) are on the outside and the tire tread points
forward.
NOTE:
For turf tires (diamond tread), be sure arrow on sidewall
points in forward rotation with windrower in cab-forward
orientation.
7. Lift wheel onto hub using a lifting device.
8. Lower lifting device.
9. Line up the holes in the rim with the studs on the wheel
drive hub and install wheel nuts (A).
IMPORTANT:
To avoid damage to wheel rims and studs, tighten nuts
by hand. Do NOT use an impact gun, do NOT use
lubricant or Never-Seez
overtighten wheel nuts.
10. Torque drive wheel nuts to 510 Nm (375 lbf·ft) using the
tightening sequence shown.
IMPORTANT:
Use only manufacturer specified nuts (MD #205397).
11. Repeat torque procedure every hour until two consecutive checks confirm there is no movement of the nuts.
214298
ASSEMBLING THE WINDROWER
®
compound, and do NOT
Figure 3.16: Wheel Position
Figure 3.17: Drive Wheel Nuts
36
Revision A