Well Log Transmission - Ricoh FAX4800L Operator's Manual

ADVANCED FEATURES
Note: You can have up to 50 fax messages in the same batch.
Messages using Confidential Transmission cannot be put into a batch.
Cross-reference
Switching Batch Transmission On/Off
In a new machine, this setting is "On". If you wish to change this setting, use the
following procedure (See page 227 if you need more information about the User
Parameter settings adjustment procedure).
1. Function 6 0 2 2 2 2 6 and 3.
2. The settings for switch 00 are now shown
on the bottom line of the display.
3. Press
until the settings for switch 06 are
shown.
The setting that you need to change is
digit 4.
4. If you wish to change the setting, press 4
on the ten key pad.
5. Finish: Yes and Function.

Well Log Transmission

Using this feature, you can transmit a document that is longer than the maximum
limit, without having to cut it up into separate sheets. However, you must contact a
service technician to have this feature switched on. The name of this feature is
taken from oil well borehole surveying. A well log is a vertical profile of a borehole,
drawn to scale, showing important data. A well log can be several yards long.
CAUTION:
If this feature is switched on permanently, users must stay by the machine while their
documents are being scanned. This is because, if the document jams, the machine may take
much longer than usual to recognize the jam; this could result in excessive wear and tear of
the mechanical components of the scanner.
If a jam does occur, press the Stop key immediately.
Sending at a Specific Time: see page 28.
USER PARAMETER
DEFAULT: 01000000
SWITCH00: 01000000
SWITCH06 : 0001 0000
Digit 4
0: The home position setting is "Off".
Batch Transmission will be disabled
after transmission. Use this if you only
wish certain transmissions to be
batched. However, you will have to
press the Batch Transmission User
Function Key for every transmission you
wish to be batched.
1: The home position is "On". If you use
Batch Transmission, it will stay on for all
transmissions, until you turn off the
lamp under the User Function Key.
TRANSMISSION
PRINT LIST →
↑
YES TO END ↓
93