Table of Contents
Advertisement
ADVANCED FEATURES
Notes:
Your machine prints all the messages that it forwards. If you do not want to it
to do this, change the setting of the user parameter (Function 63) switch 11
bit 6 to '0'.
You can select whether or not your machine transmits a forwarding mark to
be printed at the other end on the top of each page of the output. This mark
brings to the other party's attention that this message has been forwarded.
See page 8 for more about the Forwarding Mark.
If one of the senders changes their RTI/CSI/G4 TIDs, you must change the
stored RTI/CSI/G4 TIDs, or you will not be able to forward messages from that
sender.
Cross-references
RTI and CSI: see page 287.
Programming the Forwarding Feature
This section shows you how to set up your machine to forward incoming fax
messages to another location or locations.
1. Function 6 0 2 2 2 2 8 and 2.
To print a specified terminal list, press .
2. Input a two digit code from 01 to 05 for a
fowarding station number.
Example: 02
DEST.0 on the opposite display
shows that there are no RTIs/CSIs/G4
TIDs stored so far for this forwarding
station.
3. Yes.
4. Input the telephone number of this forwarding station.
If your machine is behind a PBX, add the access code before the number,
unless this forwarding station is an extension connected to the same PBX
as your machine.
Journal: see page 171.
Wild Cards: see page 118.
FORWARDING
NO. _
FORWARDING
NO.
FORWARDING
NO. 02
SET FORWARD. CODE
PRINT LIST →
NO TO CANCEL
02
DEST.0
ENTER FAX NUMBER
NO TO CANCEL
_
RECEPTION
YES OR NO
↑
↓
109
Advertisement
Table of Contents
