Table of Contents
Advertisement
SENDING A FAX MESSAGE
Normal Memory Transmission still takes place when using the following:
Send Later
Specify Multiple Destinations
The file is erased if any of the following happen during transmission:
The Stop key is pressed.
There is not enough memory available.
After a parallel Transmission fails, a communication result report is printed.
When using Parallel Transmission, page numbers are not printed at the other end.
If you want page numbers printed, use Page Count of the optional feature for
transmission (see page 29).
Sending to Just One Location
1. Make sure that the machine is in standby
mode:
The display on the operation panel must
be as shown on the right.
2. Carefully place your fax message face
down into the auto document feeder.
Note: You can dial without placing the
message in the feeder first. Place the
document after you dial the number and
go to step 4.
The pages must be placed face down in
the feeder, with the first page at the
bottom of the stack.
Feed the pages in so that the top edge
goes in first.
Do not exceed the feeder capacity:
Standard letter: Up to 50 pages at a time.
Double letter: Up to 25 pages at a time
Cross-references
Sending a Page with Very Fine Detail: See page 23.
Options for Sending a Message: See page 27.
16
Transfer Request
A document becomes jammed.
ROUTINE OPERATION
Store Double Sided
Specified Image Area
MEMORY TRANS.
SET DOC. OR ENTER FAX NO.
MEMORY TRANS.
ENTER FAX NUMBER
Do not use pages of different
sizes.
The pages should be arranged
loosely, but the leading edges
should be tidy, as shown above.
APR.4.12:25PM
MEMORY 100%
↓
OPTIONS
Advertisement
Table of Contents
