Line Type Selection - Ricoh FAX4800L Operator's Manual

APPENDIX E

Line Type Selection

When you install the optional ISDN G4 Interface Unit Type 140 , you can increase
the maximum possible line connections to 3 and connect the machine to the
ISDN. When you install the optional G3 Interface Unit Type 140, you can increase
the maximum possible line connections to 2 and connect the machine to the
PSTN.
Note : Although you must use ISDN lines for G4 communication, you can com-
municate by G3 over both ISDN and PSTN lines. Therefor, if you have con-
nected both ISDN and PSTN lines, you can use either for G3
communication. Which line is used is decided by G4 Unit setup, but if you
wish to change this setting, please contact your service representative.
Note : Line Type on the Operation Panel and on the Reports.
Display
Operation
on Operation Panel
G3 G3
G3-1 G3-1
G3-2 G3-2
G3-F* G3-F*
I-G3** I-G3**
G4 G4
* G3-F means "Use Open line". With this, the line is not designated. An open line of the same type is chosen.
** I-G3 means an ISDN G3 communication.
Line type selections for Dual Communication
With G4 Unit *(Connected the PSTN and ISDN lines)
• G3 + G4
• I-G3 + G4
* You can not select I-G3 + G3 with G4 Unit.
With G3 Unit (Connected the PSTN and additional PSTN lines)
• G3-1 + G3-2
Note : G3 (including G3-1 and G3-2) can also be used with internal lines.
Cross-references Dual Communication: see page 269.
270
Report LINE Type
G3 PSTN (FAX)
G3-1 PSTN (FAX)
G3-2 PSTN (Optional G3)
G3-F* PSTN (FAX or Op.G3)
I-G3** ISDN (Optional G4)
G4 ISDN (Optional G4)
Optional Unit
No Optional Unit
Optional G3 Kit
Optional G3 Kit
Optional G3 Kit or ISDN G4 Kit
ISDN G4 Kit
ISDN G4 Kit
Operation(G3/G4):see page 261.