Ricoh FAX4800L Operator's Manual page 112

RECEPTION
3. Change the on/off setting by pressing  or
.
4. Finsh : Yes and Function.
If you wish, you can prevent unidentified senders from sending you messages while Memory
Lock is on. See page 103.
Specifying Which Senders Messages to Lock in Memory
If you would like to receive information from only select locations into memory
lock, you can program the RTI, CSI, G4 TID codes of those locations. A terminal
sending an incoming message always identifies itself to your terminal. The
identification consists of an RTI, CSI or G4 TID. When you specify the senders for
memory lock, you must program a list of these codes.
1. Function 6 0 2 2 2 2 8 and 4.
on the opposite display shows
DEST.6
that there are 6 RTIs/CSIs/G4 TIDs
programmed so far. In a new machine,
you will see
DEST.0
At this time, you can print an Author-
ized Reception List by pressing 
Start.
2. Either:
Store some RTIs/CSIs/G4 TIDs: 1.
Go to step 3.
View the RTIs/CSIs/G4 TIDs that
you have stored: 2. Go to step 6.
means that there are 6
DEST.1/6
RTIs/CSIs programmed so far, and
the first in the list is now displayed.
Finish: Function.
3. Type in an RTI, CSI or G4 TID, then press
Yes.
Inputting labels and digits:
see page 220.
4. Either:
Store this as a wild card: Yes.
Otherwise: No.
100
.
ADVANCED FEATURES
LINE TYPE (PSTN) SELECT
ON
MEMORY LOCK SELECT _
DEST. 6
1.RTI PROG 2.RTI
MEMORY LOCK ENTER RTI/CSI
_
MEMORY LOCK
DEST. 1/6
XYZ.CO.
MEMORY LOCK
STORE AS WILD CARD?
XYZ.CO.
MEMORY LOCK ENTER RTI/CSI
_
← →
↑
OFF
YES TO END ↓
PRINT LIST →
NO TO CANCEL
NO TO CANCEL
ABC
NO TO CANCEL
CLR: CLR
↓
NO TO CANCEL
YES • NO
NO TO CANCEL
ABC