Table of Contents
Advertisement
NETWORKING
Procedure for Transfer Request by Tonal Signals
If an operator of a machine of a different manufacturer than yours wishes to use
your machine as a Transfer Station, they will have to do the following procedure.
Full Procedure
A quick reference version of this procedure is given on the next page.
1. First, the requesting party must dial your fax machine using an external
telephone.
2. Immediately after hearing fax tones from your machine, they must press #. The
tone will stop, and a single high-pitched beep of about one second duration
will be heard. This is an ACK tone (Acknowledgment).
3. The requesting party must then enter your Remote ID then press #.
See the notes at the bottom of the next page.
4. After hearing an ACK tone, they must press 2 4 #.
5. After hearing an ACK tone, they must press * * *.
6. After hearing an ACK tone, they must dial the number which the Transfer
Result Report must go to (their own terminal). This must be programmed in
your machine as a Speed Dial or Quick Dial. If it is programmed in a Quick
Dial, they must enter its number (00 to 64). Or if it is programmed in a Speed
Dial, they must enter * then its number (00 to 99). Then they must press #.
7. The requesting party has to dial the end receivers in the shorthand format used
for Transfer Request (see the quick reference procedure on the next page for
an example). Then they must press #.
For example:
Quick Dial Code 01: 0 1 #
Speed Dial Code 01: * 0 1 #
Group 01: * * 0 1 #
8. The requesting party must repeat step 7 for all the end receiver numbers. If
there are no more numbers, the requesting party should press # twice.
9. Communication begins after three ACK tones. When the requesting party hears
fax tones again, they must press Start on their fax machine.
58
ADVANCED FEATURES
Advertisement
Table of Contents
