Table of Contents
Advertisement
Attaching the Optional Handset
1. Attach the handset stand to the bracket
by two screws.
And attach the bracket with stand to the
machine by two screws.
2. To avoid slack wire hanging at the rear of
the machine, attach the cord clip.
1) Insert the cord into the clip about two
thirds down (see diagram).
2) Peel off the adhesive cover on the
cord clip.
3) Fix the cord clip to the handset
bracket as shown.
3. Plug the cable to 'Tel' jack on rear side of
the machine.
Note: Depending on which handset you
have, install the cord as shown.
Installing Optional Memory Card, Function Upgrade Card, and Fax on Demand
Switch off the power before you install the optional memory card (feature
expander), function upgrade card and fax on demand card.
Caution:
Once a Function Upgrade Card or Fax on Demand Card has been installed, do not
remove it. If removed, this will result in data being permanently lost. The Function Upgrade
Card and Fax on Demand Kit cannot be installed in the same machine.
1. Remove the cover on the left side of the
machine.
2. Insert the card with the printed face up.
Make sure that the machine and card
contacts touch.
Upper slot is for the Memory Card (Fea-
ture Expander) only. The lower slot is for
the Function Upgrade Card and Fax On
Demand Card.
3. Replace the cover.
APPENDIX F
283
Advertisement
Table of Contents
