Ricoh FAX4800L Operator's Manual page 62

NETWORKING
To store an ID Code, do the following.
1. Function 6 0 2 2 2 2 6 1 then
until the
screen is as shown opposite.
2. Yes.
3. Input the ID Code that you will be using.
Example: 4 3 6 3.
Do not use 0000 or FFFF.
4. Yes Function.
Groups
The way to program a Group is explained in Appendix F. See page 300 and the
pages following that for all the procedures. However, there are two points to keep
in mind when you are setting up Groups for networking operations.
Limitations on the size of a Group: You can store up to 200 destinations in a
Group. However, the networking features can only handle Groups that have up to
30 destinations. If you are programming a Group for networking purposes, do not
put more than 30 numbers in that Group.
Group Transfer Station: You can specify a Group Transfer Station for each of
your Groups. Then another party can send you a fax message and instruct your
machine to send it to each number in a Group, through the Group Transfer
Station, which acts as a broadcaster. Your machine will then relay the fax message
to that group's Group Transfer Station, which will then send the fax message to
each of the numbers stored in that Group. You should store Group Transfer
Stations for Groups that you wish to use with the Multi-step Transfer features. For
instructions on how to store a Group Transfer Station for a Group, see page 303.
50
ADVANCED FEATURES
POLLING ID
YES TO SET
NO TO CANCEL
POLLING ID
ID SETTING
_
POLLING ID
YES OR CLR • NO
4363
PREVIOUS ↑
NEXT ↓
YES TO END