Repairing Propshaft - Skoda Octavia II 2004 Workshop Manual

– Screw the pendulum support with new screws -arrow B- and
-arrow C- onto the gearbox ⇒ Engine; Rep. gr. 10
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Note
If droning noises occur while driving, the following must be
♦
observed.
Unscrew the propshaft with the flexible disk from the flange of
♦
the four-wheel drive clutch and screw on again offset by one
hole.
If the droning noises can still be heard, the propshaft must be
♦
screwed on once again offset to a hole.
Tightening torques:
⇒ "1.1.4 Summary of components - propshaft, Yeti", page 21
1.4

Repairing propshaft

⇒ "1.4.1 Repairing propshaft, Octavia II up to 05/2007",
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
page 43
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
1.4.1 Repairing propshaft, Octavia II up to
05/2007
Special tools and workshop equipment required
♦ Thrust washer - MP3-402 (VW 244B)-
♦ Pressure plate - MP3-406 (VW 401)-
♦ Pressure plate - MP3-407 (VW 402)-
♦ Assembly device for drive shaft - MP3-422 (VW 391)-
♦ Mandrel - MP3-448 (VW 408A)-
♦ Support bushing - MP6-428 (VW 522)-
♦ Clamping device - MP6-429 (40-204A)-
♦ Separating tool e. g. -VAS 251 409- or -Kukko 17-1-
♦ Extractor e. g. -VAS 251 415- or -Kukko 18-0-
♦ Hose binding claw
Pressing off CV joint
Pressing on CV joint
– Carefully pressing on.
– Tighten tensioner -MP6-429- , propshaft must not be pressed
down in the tensioner -MP6-429- , otherwise this could result
in paint damage.
– If necessary, remove paint damage as follows: remove resi‐
dues of grease with cellulose thinner -L 001 600- . Apply 2-
component acrylic paint -ALN 769 041- with hardener -ALZ
009 001- .
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
43
1. Propshaft