Table of Contents
Advertisement
Interfacing a DCS/PLC with the Omni FTIR Multi Gas CEMS
Connecting a DCS/PLC to the Omni FTIR Multi Gas CEMS
Connecting a
DCS/PLC to the
Omni FTIR Multi
Gas CEMS
C-2
Omni FTIR Multi Gas CEMS Instruction Manual
You can connect to the FTIR via Serial or Ethernet communications. Refer
to
Figure C–1
and the "Installation" chapter. For Modbus over Ethernet,
use TCP port 502 by default (user selectable).
The terminal block shown in
connect devices to the instrument.
Note Consult with a network engineer or system administrator for
information about making the appropriate Ethernet connection for your
application.
▲
Figure C–1. Rear Panel Terminal Connectors
Figure C–1
provides a convenient way to
Thermo Fisher Scientific
Advertisement
Table of Contents
