Figure 5-43. Insulation Removal; Figure 5-44. Hose Clamp Removal - Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual

Thermo Fisher Scientific
Figure 5–43. Insulation Removal
5. Using the flat blade screwdriver, remove the 4 hose clamps that mount
the silicone heater pad to the gas cell, then remove the heater
5–44). Note the orientation of the heater and the wires.
Figure 5–44. Hose Clamp Removal
6. Place the new heater onto the gas cell in the same orientation as the
removed heater.
7. Fasten the heater with the 4 hose clamps, tightening until snug.
8. Place the insulation back on the gas cell and attach it with a couple of
pieces of high temperature tape, making sure that it fits snugly.
9. Refer to the procedure for
cell.
Preventive Maintenance and Servicing
"Replacing the Gas Cell" to re-install the gas
Omni FTIR Multi Gas CEMS Instruction Manual
Replacing the Gas Cell Heater
(Figure
5-53