Table of Contents
Advertisement
Appendix E
IMACC Script Setting
This chapter describes the script setting for two versions of IMACC scripts.
One is named CEMS_sample mode, in which the scheduled events for
daily zero/span checks, background spectrum collection and frequent
blowback are all set and adjusted in the script setting. The other is the
Modbus control version, in which all scheduled events are triggered by
users via PLC. All scripts are saved in the same directory of c:\scrips.
CEMS_SampleMode
Script setting for CEMS_SampleMode
●
Users can open the script "CEMS_samplemode" either using the script
editor or IMACC monitor. On the IMACC monitor display, just click the
file or click "load script" button to open the script.
As indicated in the figure, there is one small setting block on the left
("Sample Mode") and one main setting block on the right ("System
Running Status"). The vertically aligned sub setting blocks contained in the
main script setting body are constructed in a sequential loop.
Thermo Fisher Scientific
Omni FTIR Multi Gas CEMS Instruction Manual
E-1
Advertisement
Table of Contents
