Temperature Control Box Components; Replacing External Fuses; Figure 5-53. Removing Ni Board From Card Cage - Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual

Preventive Maintenance and Servicing

Temperature Control Box Components

Temperature Control
Box Components
Replacing External
5-62 Omni FTIR Multi Gas CEMS Instruction Manual
Figure 5–53. Removing NI Board from Card Cage
7. Install the new board in the edge connector and re-install the mounting
screw using the Phillips screwdriver.
8. Re-install the card cage and install the 5 mounting screws using the
Phillips screwdriver.
9. Re-install the PC cover and install the 5 mounting screws using the
Phillips screwdriver.
10. Re-install the PC back into the rack by following the procedure
"Replacing the
11. Turn on the PC/Console circuit breaker on the breaker box and re-start
the PC to complete the procedure.
Use the following procedures to replace the temperature control box
internal and external components.
Use the following procedure to replace the 2 external fuses on the FTIR
temperature control box.
Fuses
Equipment Required:
Phillips screwdriver
Flat blade screwdriver
Replacement Fuses
PC".
Thermo Fisher Scientific