Appendix D Calogix Setup; Hardware Description; Figure D-1. Base Unit And Four Controllers - Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual

Hardware
Description
Thermo Fisher Scientific
Appendix D
Calogix Setup
This appendix provides a description of the Calogix software used to
control the temperature of heated sample lines and monitor the pressure in
the FTIR sample cell. For details, see the following topics:
"Hardware Description" on page
●
"Finding the Correct COM
●
"Setting the Virtual COM
●
"Programming the Controllers and Setting
●
The pressure and temperature controller hardware is located in a 2U chassis
located in the rack. It consists of four 2-channel controllers and a base unit
(Figure D–1). The hardware is connected to the system computer with a
USB cable, with a type B connector on the controller unit and type A on
the computer. The USB cable should always be connected to the computer
at the lower-left USB socket
to a 220 VAC supply from circuit breaker panel.
Figure D–1. Base Unit and Four Controllers
D-1
Port" on page D-2
Port" on page D-4
Parameters" on page
(Figure D–2). The hardware is also connected
Omni FTIR Multi Gas CEMS Instruction Manual
D-6
D-1