Figure 5-47. Pc Console Removal - Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual

Preventive Maintenance and Servicing
Replacing the PC Console
5-58 Omni FTIR Multi Gas CEMS Instruction Manual
Figure 5–47. PC Console Removal
4. Using the Phillips screwdriver, remove the 4 screws in the front of the
system that mount the PC console. Also remove the 4 screws that
secure the PC to the rack
5. Take the PC console out of the rack from the front. (Once it is part of
the way out, it is helpful to press the side tabs and compress the console
as it would be when inside the system.)
6. Before installing the new PC console, pull out the PC until it locks in
place.
7. Place the new PC console on top of the PC and slide it in until the rear
section is flush with the front of the system.
8. Push the PC console in just enough to get the rear rails on each side
started in the rack sliders. Once both sides are in place, push the
console in a couple of inches
(Figure 5–46).
(Figure 5–48).
Thermo Fisher Scientific