Connect The Purge Lines To The Ftir; Connect The Power To The Ftir; Figure 2-4. Connecting To The Ftir Unit - Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual

System Installation, Start Up and Shut Down
Installing the FTIR Analyzer into the Rack
Connect the Purge
Lines to the FTIR
Connect the Power
to the FTIR
2-6 Omni FTIR Multi Gas CEMS Instruction Manual
Connect one 1/4-inch PTFE line, marked "Purge Input" to the
corresponding quick-release fitting on the lower edge of the FTIR chassis
(Figure 2–4).
Figure 2–4. Connecting to the FTIR Unit
The FTIR power supply is located inside the rear of the FTIR shelf.
Connect the power cord from the power supply to the circular socket on
the back chassis of the FTIR. Tighten the two thumb screws attached to
the connector.
Thermo Fisher Scientific