Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual page 248

IMACC Script Setting
Modbus Control Version
E-14 Omni FTIR Multi Gas CEMS Instruction Manual
Move the cursor to the block and double click it. The detailed setting for
each monitored parameter is listed, as indicated.
As shown, there are six parameters in the register. They are sample line
temperature, short sample line inlet temperature, educator pump
temperature, gas cell temperature, gas cell pressure and short sample line
outlet temperature.
On the top of the panel, there are two buttons named "setup" and "serial".
Under the "setup" configuration, the setting panel is similar to the figure
below. Highlight the target parameter, such as SampleT, in the list. Double
click it so its subpanel pops up, as shown.
Thermo Fisher Scientific