Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual page 7

About This Manual
Safety and Equipment Damage Alerts
Alert Description
Aggressive condensate is possible. Wear protective
▲
glasses and proper protective clothing.
▲
High surface temperatures! Wear protective gloves.
▲
Flush probe in the case of toxic gases.
Perform only those procedures on the analyzer described
in this section. If there are other problems with the
analyzer, contact technical support. Also refer to the
Antaris IGS manual in the "Other Manuals" on page 1-10.
▲
The desiccant is harmful if swallowed. Follow the
manufacturer's instructions to dispose of desiccant
▲
packets properly.
To avoid shock hazard, always turn off the FTIR circuit
breaker on the breaker panel before replacing any
▲
components inside the FTIR analyzer.
CAUTION To prevent damage to the interferometer; do not apply
electric power to the analyzer before internal shipping
▲
restraints have been removed ed.
Lift from each side of the analyzer, not from the front and
▲
back. Damage to the unit may occur.
Ethernet and serial Modbus can not be implemented at
▲
the same time.
Sample gas should not be introduced to the cell until the
cell has reached 185 °C. Before air pressure is applied to
the system insure that the system is in system zero state.
Disconnect alarm connection from terminals 1 and 2 on
rear terminal block X3. This with place the system in the
state with sample valve closed and system zero valve
▲
open.
The safety instructions specific to the plant and process
▲
are to be consulted prior to any maintenance work.
Before turning off power to the probe, i.e. turning off the
heaters, the probe should be flushed with inert gas or air
in order to avoid condensation of aggressive components
of the process gas. This can best be accomplished by
▲
performing a probe zero.
High surface temperatures present. Allow sufficient time
▲
to cool.
Avoid burn and fire hazards. Do not attempt to
▲
regenerate spent desiccant packets.
The source element becomes extremely hot during
normal analyzer operation. Always turn off the analyzer
and allow the elements to cool for at least 15 minutes
Thermo Fisher Scientific Omni FTIR Multi Gas CEMS Instruction Manual iii