Imacc Ftir Software Suite (Ifss); Monitor; Figure 3-1. Component Relational Diagram - Thermo Scientific Omni FTIR Multi Gas CEMS Instruction Manual

Operation

Imacc FTIR Software Suite (IFSS)

Imacc FTIR
Software Suite
3-2 Omni FTIR Multi Gas CEMS Instruction Manual
OMNIC – Spectrometer Driver and Diagnostic software
●
Result – Spectrometer Driver software
●
CALGrafix – Heater Configuration and Diagnostic software
●
CDM – USB Driver software
●
NI DAQ – Drivers and Diagnostic software
●
The design of the software suite is intended to make the operation and
configuration of the FTIR flexible from a hardware standpoint and
expandable from a software standpoint
(IFSS)
Figure 3–1. Component Relational Diagram

Monitor

The Imacc FTIR Monitor is a user interface that displays the operational
information and analysis results of the FTIR system. As installed by
Thermo Fisher Scientific, the system computer is configured to
automatically load ImaccMonitor with a pre-configured ".layout" file when
the computer boots up. This .layout will be designed in advance for each
installation by Thermo Fisher Scientific and will call a pre-configured script
file. Both the layout and the script are also user-configurable.
(Figure 3–1).
Thermo Fisher Scientific