Thermo Fisher Scientific
5. Remove the card cage from its mount in the PC and rotate it up to
access the NI boards, being careful not to pull out any cables
51).
Figure 5–51. Positioning the Card Cage
6. Using the Phillips screwdriver, remove the mounting screw of the NI
board to be replaced, and then gently remove the board from the edge
connector. (See
Figure 5–52
Board.)
Figure 5–52. Removing NI Board Mounting Screw
Preventive Maintenance and Servicing
Replacing the National Instruments Boards
and
Figure 5–53
that show the Digital
Omni FTIR Multi Gas CEMS Instruction Manual
(Figure 5–
5-61