1.0 Introduction; 2.0 Installation Record; 2.1 X-Ray Tubes - CPI Indico 100 Series Service And Installation Manual

3A Setup Information
3A.1.0 INTRODUCTION
Please record the setup information for your installation in this section before programming the generator. Enter
the information appropriate for your generator model. The data tables will accommodate installations up to a
standard R&F installation with the following: tilting G.I. table with bucky, spot film device, standard image tube
with a medical T.V. system, wall bucky and an overhead tube stand, spot film camera and a digital acquisition
system.
3A.2.0 INSTALLATION RECORD
3A.2.1 X-Ray Tubes
Please enter the appropriate information.
a) Over table X-ray tube (or TUBE # 1)
b) Manufacturer and type:
c) Focal spot combination:
d) kW of each focal spot:
e) Maximum kVp:
f) Type of stator:
g) Dual or single speed:
h) Stator delay:
i) Start and run voltage, low speed:
j) Start and run voltage, high speed:
k) Brake voltage:
l) Maximum filament current:
m) Minimum filament current, stand-by:
n) Thermal switch included:
o) Under table X-ray tube (or TUBE # 2)
p) Manufacturer and type:
q) Focal spot combination:
r) kW of each focal spot:
s) Maximum kVp:
t) Type of stator:
u) Dual or single speed:
v) Stator delay:
w) Start and run voltage, low speed:
x) Start and run voltage, high speed:
y) Brake voltage:
z) Maximum filament current:
aa) Minimum filament current, stand-by:
bb) Thermal switch included:
cc) X-ray tube fan included:
Page 3A-2 Rev. A Millenia / Indico 100 Series Service Manual
large =
large =
sec =
start volts =
start volts =
volts =
amps =
amps =
large =
large =
sec =
start volts =
start volts =
volts =
amps =
amps =
CPI Canada Inc.
small =
small =
run volts =
run volts =
small =
small =
run volts =
run volts =
Ch # 740904-04