Programming The Low Speed Starter; Low Speed Starter Tube Select Table - CPI Indico 100 Series Service And Installation Manual

2
Installation

2.12.0 PROGRAMMING THE LOW SPEED STARTER

This section applies only to units fitted with the low speed starter.
PLEASE BE SURE TO READ AND UNDERSTAND THIS SECTION FULLY BEFORE PROCEEDING.
The low speed starter boost and run voltages are fixed at nominally 240 VAC and 50 VAC respectively.
The phase shift capacitor is fixed at 25 uF. Therefore, the low speed starter is capable of operating the "R"
type stator tubes listed in table 2-1 only.
If the desired tube type is not listed, please contact CPI product support for assistance.
WARNING: 240 VAC IS PRESENT ON THE LOW SPEED STARTER BOARD AT ALL TIMES THAT THE
GENERATOR IS SWITCHED ON. TAKE APPROPRIATE PRECAUTIONS WHEN SERVICING
THIS BOARD

2.12.1 Low Speed Starter Tube Select Table

TABLE 2-1: TUBE TYPES (LOW
SPEED STARTER)
TUBE TYPE
(HOUSING)
Comet DO7
25/50 Ω stator
Comet DO9
25/50 Ω stator
Comet DO9
25/50 Ω stator
Comet DO10
25/50 Ω stator
Comet DX10
25/50 Ω stator
Comet
XSTAR8
XSTAR74
25/50 Ω stator
Gilardoni
Rotagil S/AS
Picker
PX1300
3" anode
Std "R stator"
Picker
PX1400
4" anode
Std "R" stator
Philips
ROT350
ROT351
Page 2-16
TUBE TYPE
(INSERT)
DX7
DX9 0.6/2.0
DX9 1.2/2.0
DX91HS
DX92HS
DX93HS
DX10HS 0.6/1.0
DX10HS 1.0/2.0
DX101HS
DX104HS
DX105HS
XST-8
XST-74
AR11-30
AR30-60
PX1302
PX1312
PX1429
PX1431
PX1436
PX1482
RO 17/50
SRO 22/50
SRO 33/100
Rev. H Indico 100 Series Service Manual
CPI Canada Inc.
Ch # 740895-04