CPI Indico 100 Series Service And Installation Manual page 261

CPI Canada Inc
NOTE (Cont):
12. These items only used on dual speed starter option, spares should be stocked accordingly. Several part
numbers of dual speed starter (which are tube stator dependent) are used in Indico 100 generators. To
determine which dual speed starter assembly is in your generator, note the DUAL SPEED STARTER
ASSY part number on a label on the dual speed starter chassis. This will be the part number that must
be ordered for spares usage. For reference, this will be part number 733317-XX or 735925-XX where XX
is a two digit number designating the exact configuration.
The dual speed starter fuses listed are used on all four versions of dual speed starter.
13. These items are used on the 400/480 VAC 3 phase power input board. Spares should be stocked
accordingly.
14a. These items are used on 1 phase 230 VAC units only (on the DC bus assembly or on the 1 phase power
input board). Spares should be stocked accordingly.
14b. This fuse used on 1 phase 230 VAC rad two tube generators, and on 1 phase 230 VAC R & F one tube
and two tube generators. Spares should be stocked accordingly.
15. Two different room I/F transformers are used in Indico 100 generators. For 230 VAC 1 phase generators
use part number 733685-00, for 400 and 480 VAC 3 phase generators use part number 732179-00.
16. For replacement HT oil tank part numbers, consult factory.
17. NOTE REGARDING MAINS (LINE) VOLTAGE AS DESCRIBED IN THIS SECTION: The mains voltage
referenced in this section is the mains voltage at the input to the generator (at the main fuses on the
power input board). This is not necessarily the same as the voltage at the main disconnect box in the
room, the reason being that an optional line adjusting transformer may be used with the generator which
steps the incoming line voltage to the generator up or down. To ensure that the correct part number is
selected for spares, it is suggested that the mains voltage be noted at the main input fuses INSIDE THE
GENERATOR.
18. The digital I/O board is optional, and used on generators intended to interface with digital imaging
systems. To ensure full compatibility, please order the same part number that is in your generator(s).
19. The hand switch assembly is optional, and is normally dealer installed.
20. A cooling fan is used on R&F power supplies only. Spares should be stocked accordingly.
21. For 23 X 56 cm consoles, use LCD display assembly part number 733396-00. For 31 X 42 cm consoles,
use LCD display assembly part number 735895-00.
22. For 23 X 56 cm consoles, use hand switch assembly part number 733176-00. For 31 X 42 cm consoles,
use hand switch assembly part number 735203-00.
Indico 100 Series Service Manual Ch # 740895-07 Rev. K
8
Spares
Page 8-5