2.2 Mains Supply And Fusing; 2.3 Automatic Exposure Control; 2.4 Collimator; 2.5 Image System - CPI Indico 100 Series Service And Installation Manual

CPI Canada Inc.
3A.2.2 Mains Supply And Fusing
Please record the following information on the mains voltage and current capacity. Check that the information is
appropriate for the generator according to the nameplate on the generator cabinet.
Line voltage: ________ VAC
Line frequency:
Disconnect fuses (main):
3A.2.3 Automatic Exposure Control
Chamber Type (optional):
Solid State: __________________
Make: _______________________
Receptors with AEC (optional):
Table bucky
Wall bucky
3A.2.4 Collimator
Type:
Compatible with X-ray tube:
Exposure interlock (dry contacts):
Tomo/stereo by-pass:
3A.2.5 Image System
Conventional: ________________________________________ (make and model)
Digital: ______________________________________________(make and model)
Image intensifier:
24 hour supply:
Image system park/position switch.
Fluoro foot switch to initiate fluoro and spot exposure:
Spot film advance delay: greater than 850 mSec. __ yes
Remote Fluoro controller.
AEC compensation for multi-spot SFD use.
Millenia / Indico 100 Series Service Manual
50 Hz. 60 Hz.
amps
Ion Chamber ______________
Model: _________________
yes Spot film device
yes Auxiliary bucky
Line capacity:
yes
yes
__________________
yes
yes
yes
dual mode
__ yes
__ yes
__ yes
__ no
__ yes
__ yes
Ch # 740904-04 Rev. A
Setup Information
kVa
PMT _____________
Digital System
no
no
no
tri-mode
__ no
__ no
__ no
__ no
__ no
3A
yes
Page 3A-3