5.0 Safety Labels / Notices Common To Millenia And Indico 100; 5.1 Caution Hv Behind Cover Label - CPI Indico 100 Series Service And Installation Manual

CPI Canada Inc.
1B.5.0 SAFETY LABELS / NOTICES COMMON TO MILLENIA AND INDICO 100
1B.5.1 Caution HV Behind Cover Label
MILLENIA:
MILLENIA:
MILLENIA:
MILLENIA:
INDICO 100:
INDICO 100:
Millenia / Indico 100 Series Service Manual
This label is attached to a cover over the main power contactor. This area will have mains
voltage applied as long as the main disconnect is switched on.
This label is attached to a cover over the resonant circuit and low speed starter
components if a low speed starter is fitted. The resonant components (resonant
capacitors etc) may be energized for 5 minutes after the console is switched off, or the
main disconnect is switched off.
If a low speed starter is fitted, the associated components will have up to 240
VAC applied when the console is switched on.
This label is attached to each of the access panels on the rear of the generator. The high
voltage hazards behind these panels is similar to that behind the upper and lower
entrance doors, see 1B.7.4.
This label is attached to a cover over the line adjusting transformer (if fitted). The
terminals on the transformer will have mains voltage applied as long as the main
disconnect is switched on. If access to the transformer connections is needed, SWITCH
OFF THE MAIN DISCONNECT FIRST.
This label is attached to a cover over the inverter board(s). The inverter assembly is
connected to the main DC bus and will have high voltage applied at all times that the
generator is switched on. This assembly will remain energized for 5 minutes after the
generator is switched off, or the main disconnect is switched off.
This label is attached to a cover over the main input fuses on the power input board. This
area will have mains voltage applied as long as the main disconnect is switched on.
Ch # 740904-01 Rev. D
1B
Safety
Page 1B-5