CPI Canada Inc.
4.1.0 INTRODUCTION ........................................................................................................................................... 4-1
4.3.0 CONSOLE OVERVIEW ................................................................................................................................. 4-3
4.4.1 Console Rad Tests..................................................................................................................................... 4-4
4.4.2 Console Fluoro Tests ................................................................................................................................. 4-5
4.5.1 Generator Rad Tests.................................................................................................................................. 4-9
4.5.2 Generator Fluoro Tests ............................................................................................................................ 4-13
4.7.0 ACCEPTANCE TESTS (AEC) ..................................................................................................................... 4-15
4.8.0 ACCEPTANCE TESTS (ABS) ..................................................................................................................... 4-15
4.1.0
INTRODUCTION
This section details acceptance testing, which verifies that the generator is performing within limits. It is
recommended that this be done whenever the generator is reconfigured, or component(s) are replaced
which may affect the X-ray output. Examples of such components are the X-ray tube, HT tank, generator
CPU board, generator interface board, AEC board, control board 1 and control board 2 in the HF power
supply, and the filament supply board(s).
Millenia / Indico 100 Series Service Manual
CHAPTER 4
ACCEPTANCE TESTING
CONTENTS:
Ch # 740904-08
Acceptance Testing
Rev. F
4
Page 4-1