Introduction; Receiving - CPI Indico 100 Series Service And Installation Manual

2
Installation
2.1.0

INTRODUCTION

This chapter contains instructions for unpacking, positioning, and cabling the Indico 100 series of
generators to allow initial operation and calibration. The instructions in this chapter allows the installation
engineer to:
•
Install the generator and control console.
•
Install the optional remote fluoro control.
•
Connect power.
•
Calibrate one or two X-ray tube(s), depending on the generator model, without completing the room
interface connections. This allows for simpler installation and troubleshooting on the generator itself.
2.2.0

RECEIVING

WARNING: THE INDICO 100 GENERATOR CONSISTS OF THE FOLLOWING ITEMS: UPPER AND
LOWER CABINETS (FACTORY ASSEMBLED), CONTROL CONSOLE, AND AN OPTIONAL
REMOTE FLUORO CONTROL.
THE COMPLETE GENERATOR WEIGHS APPROXIMATELY 250 POUNDS (115 KG) IN ITS
SHIPPING CONTAINER.
ENCLOSURE, THE WEIGHT OF THAT ASSEMBLY IS APPROXIMATELY 100 POUNDS (45
KG).
THE OIL TANK IS LOCATED IN THE LOWER (POWER SUPPLY) CABINET. ONE PERSON
SHOULD NOT ATTEMPT TO LIFT OR MOVE THE GENERATOR ASSEMBLY OR OPTIONAL
LINE ADJUSTING TRANSFORMER WITHOUT ADEQUATE ASSISTANCE OR PROPER
EQUIPMENT.
Page 2-2
THE OPTIONAL LINE ADJUSTING TRANSFORMER IS SUPPLIED IN A SEPARATE
Rev. H Indico 100 Series Service Manual
CPI Canada Inc.
Ch # 740895-04