Major Shipping Assemblies; Removal From Pack - CPI Indico 100 Series Service And Installation Manual

CPI Canada Inc.
2.2.1

Major Shipping Assemblies

Refer to figure 1A-2 (chapter 1A). This shows the upper (control cabinet) and lower (power supply) cabinet
fully assembled, along with the control console and optional remote fluoro control unit.
2.3.0

REMOVAL FROM PACK

1. Inspect the pack for evidence of shipping damage. If there is evidence of shipping damage, note
this in the event that a damage claim is justified.
2. Locate any documentation attached to the outside of the cardboard sleeve. Be sure to read and
understand this documentation before unpacking the generator. Then set this documentation
aside temporarily until it can be transferred to a storage location close to the generator for future
reference.
3. Remove the cardboard outer pack(s).
CAUTION: OPEN THE CARDBOARD PACK(S) CAREFULLY. SHARP TOOLS MAY DAMAGE THE
CONTENTS.
4. Set aside the cardboard pack(s).
5. Unscrew the bolts that secure the generator to the shipping pallet. Carefully lift the generator from
the pallet. Refer to 2.3.1 for the procedure for lifting the generator.
6. Inspect for internal and external shipping damage. Refer to 2.4.0 for instructions for removing the
external covers.
7. Unscrew the levelling feet at the bottom of the generator by a minimum of 1 1/2" (35 mm). This
will provide the required air flow underneath the generator cabinet and allow room to make
levelling adjustments when the generator is placed in its final location.
8. Remove and unpack the control console, the optional line adjusting transformer if used, the
optional remote fluoro control if used, and the optional handswitch kit if included, and check these
items for any damage.
9. Remove and unpack the manuals and any other paperwork that may be packed with the
generator.
10. Keep the shipping containers. In case of shipping damage, place the unit(s) back in its shipping
pack and notify the carrier and the customer support group at CPI Canada Inc.
Indico 100 Series Service Manual Ch # 740895-04 Rev. H
2
Installation
Page 2-3