Hand Switch Installation - CPI Indico 100 Series Service And Installation Manual

CPI Canada Inc.
2.9.3

Hand Switch Installation

FOR 23 X 56 (CM) CONSOLES: The optional hand switch is supplied as a kit which must be user
installed. If this option is used, refer to separate installation instructions packaged along with the hand
switch.
For reference, a drawing is supplied in this section showing the hand switch connections to the
console CPU board. See figure 2-5.
FOR 31 X 42 (CM) CONSOLES: The optional hand switch, if ordered from CPI Canada Inc, is supplied
pre-wired to a male 9 pin subminiature 'D' connector. This connects to J13 on the rear of the console.
Fluoro foot switch connections may also be made to this connector. The table below shows the pin
designations for J13. A male 9 pin subminiature 'D' connector will need to be provided by the installer if
the CPI supplied hand switch is not used.
J13 PIN NUMBER
1
2
3
4
5
6
7
8
9
Indico 100 Series Service Manual
Figure 2-5: Hand switch connections on console CPU board
Hand Switch: X-Ray
No Connection
Hand Switch: Prep
No Connection
Hand Switch: Common (ground)
No Connection
Foot Switch: 'live' terminal
No Connection
Foot Switch: 'ground' terminal
Ch # 740895-04
DESCRIPTION
Rev. H
2
Installation
Page 2-11