Removing The External Covers - CPI Indico 100 Series Service And Installation Manual

CPI Canada Inc.
2.4.0

REMOVING THE EXTERNAL COVERS

NOTE: A POTENTIAL HAZARD EXISTS TO OPERATORS, SERVICE PERSONNEL, OR TO THE
EQUIPMENT IF THE GENERATOR IS OPERATED WITH ANY OF THE GROUND LEADS TO
THE EXTERNAL COVERS DISCONNECTED OR IMPROPERLY CONNECTED.
ANY PROCEDURE THAT REQUIRES THEIR REMOVAL.
REFER TO FIGURE 2-2 FOR IDENTIFICATION OF COVERS/PANELS DESCRIBED IN THIS
SECTION.
Lower Access Panels
Remove the two screws at the bottom of the panel to be removed. Carefully lower the panel such as to
allow the locating tabs at the top of the panel to clear the slots in the lip of the frame. The panel may then
be lifted away from the frame.
If it is required to temporarily remove the ground wire connected to the panel, remove the nut that
secures the ground lead to the cabinet frame and then disconnect the ring terminal.
Reverse the above steps to reconnect the ground wire(s), and to reinstall the access panel(s).
Lower Wiring Access Panel
THIS PANEL IS NOT FITTED IF THE OPTIONAL WIRING CHANNELS ARE USED.
Remove the screw from the upper right hand corner of the panel. Pull out the snaps on the three nylon
fasteners such as to release the panel. Remove the panel from the generator.
Upper Wiring Access Panel
THIS PANEL IS NOT FITTED IF THE OPTIONAL WIRING CHANNELS ARE USED.
Pull out the snaps on the two nylon fasteners, then remove the screws from the upper left hand and upper
right hand corners of the panel. Remove the panel from the generator.
If it is required to temporarily remove the ground wire connected to the panel, remove the nut that
secures the ground lead to the access panel and then disconnect the ring terminal.
Reverse the above steps to reconnect the ground wire(s), and to reinstall the access panel(s).
Indico 100 Series Service Manual
BE SURE TO PROPERLY RECONNECT ALL GROUND LEADS AFTER COMPLETING
Ch # 740895-04 Rev. H
2
Installation
Page 2-5