4.0 Safety Warning Labels - Introduction; 4.1 Safety Warning Labels - Organization - CPI Indico 100 Series Service And Installation Manual

1B
Safety
1B.4.0 SAFETY WARNING LABELS - INTRODUCTION
The safety warning label subsections define the safety labels used inside and outside the generator
cabinets. Depending on configuration, your X-ray generator may contain some or all of the labels shown.
NOTE: THESE LABELS AND WARNINGS ARE LOCATED TO ALERT SERVICE PERSONNEL THAT
SERIOUS INJURY WILL RESULT IF THE HAZARD IDENTIFIED IS IGNORED.
NOTE: DUE TO THE DIVERSITY OF GENERATOR MODELS, THE EQUIPMENT MAY NOT BE
EXACTLY AS SHOWN.
WARNING: SWITCH OFF THE MAIN POWER DISCONNECT AND ALLOW SUFFICIENT TIME FOR ALL
CAPACITORS TO DISCHARGE BEFORE REMOVING ANY COVERS OR OPENING ANY
SERVICE DOOR.
WARNING: IF ANY BARRIERS OR COVERS MUST BE REMOVED FOR SERVICE, TAKE ALL REQUIRED
PRECAUTIONS WITH RESPECT TO THE HAZARD(S) AND IMMEDIATELY REPLACE THE
BARRIERS/COVERS WHEN THE NEED FOR REMOVAL IS COMPLETED.
REPLACE ALL FUSES IN THIS GENERATOR WITH THE SAME TYPE AND
RATING.
This information is provided to help you establish safe operating conditions for both you and your CPI X-
ray generator. Do not operate this X-ray generator except in accordance with these precautions, and any
additional information provided by the X-ray generator manufacturer and/or competent safety authorities.
1B.4.1 Safety Warning Labels - Organization
The safety warning label information is organized into three subsections:
•
Safety labels/notices common to Millenia and Indico 100
•
Safety notices unique to Millenia
•
Safety notices unique to Indico 100
Page 1B-4 Rev. D Millenia / Indico 100 Series Service Manual
CPI Canada Inc.
Ch # 740904-01