Table of Contents
Advertisement
22
List of Figures
Pos: 30 /Alle Serien (Allgemeine Module)/Überschriften/Ebene 2/Bedienelemente - Überschrift 2 @ 4\mod_1239191655456_21.docx @ 30439 @ 2 @ 1
3.4
Operating Elements
Pos: 31 /Serie 750 (WAGO I/O SYSTEM)/Gerätebeschreibung (alte Struktur)/Bedienelemente/Bedienelemente I/O-Modul 750-0940 @ 36\mod_1589033816486_21.docx @ 581847 @ 3 @ 1
The EnOcean Gateway is configured with two DIP switch panels.
Figure 9: Operating Elements on the EnOcean Gateway
Table 9: Operating Elements on the EnOcean Gateway
Item
Description
1
Four-position DIP switch ("DIP2") for setting the EnOcean Gateway
hardware properties.
2
Eight-position DIP switch ("DIP1") for the additional settings for Modbus
mode
To accept configuration changes, restart EnOcean Gateway.
The DIP switch settings are only read out when the EnOcean Gateway is started.
To activate changed DIP switch settings during operation, the EnOcean Gateway
must be restarted by switching the power supply off and back on.
Manual
Version 1.3.0, valid from FW/HW Version 01/01
750-940 EnOcean RS-485 Gateway; 868 MHz
WAGO I/O System 750
Advertisement
Table of Contents
