Table of Contents
Advertisement
18
Device Description
Pos : 29 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Gerätebesc hreibung/Bedienel emente - Ü berschrift 2 @ 4\mod_1239191655456_21.doc x @ 30439 @ 2 @ 1
3.4
Operating Elements
Pos : 30 /Serie 753 ( WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/Bus klemmen/Bedienelemente 753- 0646 @ 5\mod_1254117851375_21.doc x @ 42200 @ @ 1
The I/O module has two programming button connections (see figure below) for
parameterization of the KNX module in the device mode.
Figure 4: Programming button
Actuation of the buttons is requested by the engineering tool software (ETS)
during startup of the module.
A temporary electrical connection is established between these two programming
button connectors (2 and 6), via a wire jumper for example, which activates the
programming mode.
Pos : 31 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
753-646 KNX/EIB/TP1 Module
Version 1.1.0
Manual
Advertisement
Table of Contents
