259 - BCS Line User Manual

259

NTP Server is enabled.
Parameter
Mobile Push
Notifications
CGI
ONVIF
NTP Server
SSH
Enable Device
Discovery
Private Protocol
Authentication Mode
Step 3 Click Apply to complete the settings.
1.14.2.2 802.1x
The device needs to pass 802.1x certification to enter the LAN.
Step 1 Select Main Menu > SECURITY > System Service > 802.1x.
The 802.1x interface is displayed. See Figure 4-269
Copyright © NSS Sp. z o.o.
Table 4-84 Basic service parameters
Description
After enabling this function, the alarm triggered by the NVR can
be pushed to a mobile phone. This function is enabled by
default.
If this function is enabled, the remote devices can be added
through the CGI protocol. This function is enabled by default.
If this function is enabled, the remote devices can be added
through the ONVIF protocol. This function is enabled by default.
After enabling this function, a NTP server can be used to
synchronize the device. This function is enabled by default.
After enabling this function, you can use SSH service. This
function is disabled by default.
After enabling this function, the NVR can be found by other
devices trough searching.
● Security Mode (Recommended): Uses Digest access
authentication when connecting to NVR.
● Compatible Mode: Select this mode when the client does not
support Digest access authentication.
259
User's Manual