Enabling Password Reset Function - BCS Line User Manual

User's Manual
● If the password reset function is enabled, you can use mobile phone to scan the QR code to
reset the password. For details, see "4.1.3.2 Resetting Password on Local Interface".
● If the password reset function is disabled, there are two situations:
If you configured security questions, you can reset the password by the security
◇
questions.
If you did not configure the security questions, you can only use the reset button on the
◇
mainboard to restore the Device to factory default.
Reset button is for some series product only.

1.1.3.1 Enabling Password Reset Function

After enabling password reset function, you can scan QR code on the local menu to reset
password.
Step 1 Select Main Menu > Account > Password Reset.
The Password Reset interface is displayed. See Figure 4-6.
Step 2 Check the box to enable reset function.
This function is enabled by default.
Step 3 Click Apply to set settings.
If the password reset function is disabled, you can follow the ways listed below to
reset password.
● Device supports Reset button on the main board: You can answer the security
question on the local menu or click the Reset button on the main board to reset
password. Refer to "1.1.3.3 Reset Button" for detailed information.
● Device does not support Reset button on the main board: You can only answer the
security question on the local menu to reset password. (Make sure you have set
security questions).
1.1.3.2 Resetting Password on Local Interface
Figure 4-6
6
Copyright © NSS Sp. z o.o.
6