Reset Button - BCS Line User Manual

13
A pop-up message is displayed asking if you want to sync the password with the
remote devices. See Figure 4-14. Click OK to synchronize password to remote
devices.

1.1.3.3 Reset Button

You can always use the reset button on the mainboard to reset the Device to the factory default
settings.
Reset button is for some series products only.
Step 1 Disconnect the Device from power source, and then remove the cover panel. For
details about removing the cover panel, see "3.4 HDD Installation".
Step 2 Find the reset button on the mainboard, and then connect the Device to the power
source again.
Step 3 Press and hold the reset button for 5 seconds to 10 seconds. See Figure 4-15 for the
location of the reset button.
Step 4 Reboot the Device.
After the Device is rebooted, the settings have been restored to the factory default.
You can start resetting the password.
Copyright © NSS Sp. z o.o.
Figure 4-14
Figure 4-15
13
User's Manual