5: Projector Operation; Turn The Projector On; Turn The Projector Off; Projector Power States - Christie CP4230 User Manual

5 Projector Operation
This section provides information and procedures for operating the projector.
5.1

Turn the Projector On

WARNING! Do not attempt to turn the projector on if the AC supply is not within the
specified voltage range.
1. Turn the circuit breaker for the projector on.
2. On the Touch Panel Controller (TPC), tap and hold the green power
3. On the TPC, tap and hold the light bulb
5.2

Turn the Projector Off

1. On the Touch Panel Controller (TPC), tap and hold the light bulb
2. On the TPC, tap and hold the red power
and electronics stay on for 10 minutes. After this cool down period, the projector enters standby mode.
3. If you are servicing the projector, or removing the protective cover, disconnect AC and turn the breaker
OFF.
5.3

Projector Power States

This table identifies what occurs when you press the Power and Lamp icons on the Touch Panel Controller
(TPC).
Table 5.1 Projector Status when any TPC Lamp or Power Buttons Selected
Power ON
Power OFF
Lamp ON
Lamp OFF
CP4230 User Manual
020-100621-02 Rev. 1 (01-2012)
Downloaded From projector-manual.com Christie Manuals
Standby Power Mode Power ON/ Lamp OFF
(Solid Yellow) (Green Blip)
To full power ON No action
(boot delay)
No action Power OFF
immediately
To power ON and lamp To lamp ON
ON (boot delay) (immediately)
No action No action
icon to ignite the lamp.
icon to turn the lamp off.
icon. The projector enters a cool down mode and the fans
Projector's Current State:
Power ON / Lamp ON
(Solid Green)
No action
Lamp OFF (immediately),
enters cool down mode
No action
Lamp OFF (immediately) No action
icon.
Cooling Down
Mode (Yellow Blip/
Green Blip)
Cancels cool down,
goes into full power
No action
Cancels cool down,
goes to Lamp ON
(immediately)
5-1