Projector Power States; Projector Led Status Indicators - Christie CP 2210 User Manual

Section 3: Operation
5.3

Projector Power States

The following table identifies what occurs when the TPC's Power and Lamp buttons are tapped during any of
the projector's 4 main power states. See Table
Table 5.1 Projector Status when any TPC Lamp or Power Buttons Selected
Power ON
Power OFF
Lamp ON
Lamp OFF
5.4

Projector LED Status Indicators

Red, yellow, and green LEDs on the top and rear corners of the projector indicate the status of the projector.
The LEDs can be solidly lit, or they can flash frequently or intermittently. This table lists the LED state and the
associated meaning:
Table 5.2 Projector Status LED Legend
LED
Solid Green
Green Blip
Solid Yellow
Yellow Blip/
Green Blip
Flashing Red
Solid Red
5-2
Standby Power Mode
(Solid Yellow)
To full power ON
(boot delay)
No action
To power ON and lamp
ON (boot delay)
No action
State Description
Lamp ON Power is ON, Lamp is ON.
Power ON Power is ON, Lamp is OFF. The lamp can be struck when in this mode.
Standby mode Power is OFF, Lamp is OFF. Power saving mode.
Cool down mode Transitioning to Standby mode. Power is ON, Lamp is OFF.
The lamp can be struck when in this mode.
New critical alarm New critical alarm or warning has NOT been acknowledged by operator.
or warning
Existing critical Critical alarm or warning exists, but has been acknowledged by operator.
alarm or warning
5.1.
Projector's Current State:
Power ON/ Lamp OFF Power ON / Lamp ON
(Green Blip) (Solid Green)
No action No action
Power OFF Lamp OFF (immediately),
immediately enters cool down mode
To lamp ON No action
(immediately)
No action Lamp OFF (immediately) No action
Cooling Down
Mode (Yellow Blip/
Green Blip)
Cancels cool down,
goes into full power
No action
Cancels cool down,
goes to Lamp ON
(immediately)
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)