Projector Power States; Projector Led Status Indicators - Christie CP2210 User Manual

Section 3: Operation
5.3

Projector Power States

The following table identifies what occurs when the TPC's Power and Lamp buttons are tapped during any of
the projector's 4 main power states. See Table
Table 5.1 Projector Status when any TPC Lamp or Power Buttons Selected
Power ON
Power OFF
Lamp ON
Lamp OFF
5.4

Projector LED Status Indicators

Red, yellow, and green LEDs on the top and rear corners of the projector indicate the status of the projector.
The LEDs can be solidly lit, or they can flash frequently or intermittently. This table lists the LED state and the
associated meaning:
Table 5.2 Projector Status LED Legend
LED
Solid Green
Green Blip
Solid Yellow
Yellow Blip/
Green Blip
Flashing Red
Solid Red
5-2
Downloaded from ProjectorsManual.com Manuals
Standby Power Mode Power ON/ Lamp OFF
(Solid Yellow) (Green Blip)
To full power ON No action
(boot delay)
No action Power OFF
immediately
To power ON and lamp To lamp ON
ON (boot delay) (immediately)
No action No action
State Description
Lamp ON Power is ON, Lamp is ON.
Power ON Power is ON, Lamp is OFF. The lamp can be struck when in this mode.
Standby mode Power is OFF, Lamp is OFF. Power saving mode.
Cool down mode Transitioning to Standby mode. Power is ON, Lamp is OFF.
The lamp can be struck when in this mode.
New critical alarm New critical alarm or warning has NOT been acknowledged by operator.
or warning
Existing critical Critical alarm or warning exists, but has been acknowledged by operator.
alarm or warning
5.1.
Projector's Current State:
Power ON / Lamp ON
(Solid Green)
No action
Lamp OFF (immediately),
enters cool down mode
No action
Lamp OFF (immediately) No action
Cooling Down
Mode (Yellow Blip/
Green Blip)
Cancels cool down,
goes into full power
No action
Cancels cool down,
goes to Lamp ON
(immediately)
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)