Turn The Cinema Projector On; Turn The Cinema Projector Off; Cinema Projector Power States - Christie CP2220 User Manual

5 Operation
This section provides information and procedures for operating the CP2220 cinema projector.
5.1

Turn the Cinema Projector On

WARNING! Do not attempt to turn the cinema projector on if the AC supply is not within the
specified voltage range.
1. Turn the circuit breaker for the cinema projector on.
2. On the Touch Panel Controller (TPC), tap and hold the green power
3. On the TPC, tap and hold the light bulb
5.2

Turn the Cinema Projector Off

1. On the Touch Panel Controller (TPC), tap and hold the light bulb
2. On the TPC, tap and hold the red power
the fans and electronics stay on for 10 minutes. After this cool down period, the cinema projector enters
standby mode.
3. If you are servicing the cinema projector, or removing the protective cover, disconnect AC and turn the
breaker OFF.
5.3

Cinema Projector Power States

This table identifies what occurs when you press the Power and Lamp icons on the Touch Panel Controller
(TPC).
Power ON
Power OFF
Lamp ON
Lamp OFF
CP2220 User Manual
020-100420-08 Rev.1 (5-2014)
Standby Power Mode Power ON/ Lamp OFF
(Solid Yellow) (Green Blip)
To full power ON No action
(boot delay)
No action Power OFF
immediately
To power ON and To lamp ON
lamp ON (boot delay) (immediately)
No action No action
icon to ignite the lamp.
icon. The cinema projector enters a cool down mode and
cinema projector's Current State:
Power ON / Lamp ON
(Solid Green)
No action
Lamp OFF
(immediately), enters
cool down mode
No action
Lamp OFF
(immediately)
icon.
icon to turn the lamp off.
Cooling Down
Mode (Yellow Blip/
Green Blip)
Cancels cool down,
goes into full
power
No action
Cancels cool down,
goes to Lamp ON
(immediately)
No action
5-1