Replacing Keypad Batteries; Replacing The Lens - Christie Mirage S+14K User Manual

MAINTENANCE
4.3 Replacing
Keypad
Batteries
4.4 Replacing the
Lamp and Filter
Lamp Replacement
Procedure
4-4
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
The IR Remote Keypad uses two AA size, 1.5V batteries (preferably alkaline). To
install new batteries, 1) open the battery compartment at the back side of the keypad
by placing your thumb in the oval depression and sliding the cover out about ½ inch.
See Figure 4.1.
Remove the old batteries
and properly discard. Wait
a minute or two, and 2)
place the new batteries in
the compartment, orienting
the positive/negative
each battery according to
the labels in
compartment. When the
batteries are in
replace the cover
placing the cover ½ inch
from its closed position and slide it into place. Do not force the cover.
NOTE: Always wait a minute or two when replacing batteries so that the internal
electronics discharge and can recognize the change.
NOTE: For this procedure you will need the appropriate "Roadster S+12K,
RoadsterS+16K, or Mirage S+14K / Easy Rider Lamp and Filter Replacement Kit"
manufactured by Christie Digital Systems.
The high brightness of your projector is provided by a bubble lamp permanently
mounted inside its own protective assembly. Using this module beyond its warranted
life is not recommended—changes in the quartz of the bulb can lead to reliability
problems, poor performance or sudden lamp expiry. The filter should always be
changed when the lamp is replaced, or sooner in dusty environments.
The lamp module is calibrated for maximum performance and brightness in this
projector. Do not attempt to re-align or adjust the lamp module.
How Old is the Lamp?
The number of hours logged on the current lamp appears both in the Lamp menu and
the Status menu. In the Status menu, do not confuse "Lamp Hours" with "Lamp
Counter" which indicates the number of hours logged during the current rental period
only and is normally used just for Roadster S+ / Mirage S+ rental projectors
NOTE: As the lamp nears its limit (as set in Lamp Limit), a message can appear on
screen to warn that the lamp needs to be replaced. To make sure that this warning
appears, enter a checkmark in the Lamp Message checkbox located in the Lamp
submenu.
'
TOOLS:
A #2 Phillips screwdriver is required. All access panels screws are ¼-turn to
lock/unlock.
of
the
place,
by
WARNING
Protective gear required.