Lens mount
components
The lens mount provides a means of securing a projection lens to the projector. Components include
the lens boot, lens mount barrel, and the lens mount offset.
Removing the projection lens
Use the correct method of removing the lens.
1. For motorized lens mounts only, disconnect the lens zoom motor from the two zoom motor
harness connectors.
2. Turn the clamp on the lens mount to unlock the projection lens.
3. Slide the lens straight out of the projector.
If the lens does not slide out easily, reset the lens offset.
4. Attach the lens cap to avoid damage to the lens.
Replacing the lens mount
The lens mount, located at the front of the projector, is an assembly of mechanical and electrical
components that securely holds and positions the projection lens.
1. Remove the front cover (on page 42).
2. Remove the projection lens (on page 34).
Cinema 4K-RGB Service Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102713-03 Rev. 1 (11-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
34