Replacing The Lens - Christie CP2208-LP Service Manual

Replacing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. On the touch panel controller (TPC) Main screen, tap and hold the red power button to turn off
the light source and projector.
2. Allow the light source to cool for a minimum of 15 minutes.
3. Disconnect the projector from AC power or turn the circuit breaker off.
4. Remove the lens surround.
5. Install the lens cap and turn the lens clamp to the open position with a hex key.
6. If necessary, remove the two cap screws securing the lens to the lens mount using a hex key.
7. Pull the lens out of the lens mount and then install a small lens cap on the rear of the lens.
8. Remove the small rear cap from the new lens.
Keep the front cap on.
9. Align the tabs on the lens plate with the lens mount.
10. Insert the lens until it connects with the magnets on the mount.
When the lens contacts the magnetic plates it is seated correctly.
11. Secure the lens clamp by rotating it clockwise with a hex key.
12. Tighten the lens mount cap screws for added stability.
13. Replace the lens surround.
14. Remove the lens cap from the front of the lens.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Optics
78