Replacing The Lens Support Kit - Christie J Series Service Manual

6. Remove the fold mirror.
7. To re-install, complete these steps in reverse order.
When installing, place the mirror with the reflective surface facing into the projector, toward
the optical assembly. To determine which side is the reflective side, place your finger on the
edge of the mirror face and see if there is a gap between your finger and its reflection. No gap
indicates the closest reflective side.
8. Adjust the fold mirror (on page 21).

Replacing the lens support kit

Complete the following procedure to replace the lens support kit.
Estimated time to replace: 10 minutes.
1. To release the pressure against the lens, loosen the brass knurled nut.
2. Remove the CT mounted (on page 81) or ILS mounted (on page 82) lens.
3. Carefully peel away the bottom lens support bracket.
The bottom lens support bracket is secured with double-sided tape.
4. Determine which of the three screws fits the gap between the lens and the bottom of the
projector lens cavity.
5. Thread half the screw through the flat side of the brass knurled nut.
6. Place the top lens support block over the end of the screw.
7. Remove the adhesive covering from one side of the double sided tape.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
76