System Operation; Startup Wizard; Operation (Local) - Toshiba WX9 ASD Installation & Operation Manual

System Operation

Startup Wizard

Upon initial system power-up, the Startup Wizard may be run to assist the user with the initial
configuration of the input power settings and the output parameters of the WX9 ASD. The WX9 ASD
may also be set up by directly accessing each of the individual parameters (see the section titled
Access Parameter Information on pg.
more information on changing the parameter settings.
The Startup Wizard is run from the menu path Program  Startup Wizard.
The Startup Wizard querys the user for the following information:
Note: Finish may be clicked after any entry to load the Startup Wizard settings and exit.
1. Run now? (if selected, continue on to step #2); Run next time at power up? (if selected, go to
Program screen); Manually configure? (if selected, click Finish
2. The Voltage and Frequency Rating of the Motor
3. The Upper-Limit Frequency
4. The Lower-Limit Frequency
5. Adjust Accel/Decel Automatically?
6. The Acceleration Time
7. The Deceleration Time
8. The Volts Per Hertz Setting
9. The Motor Current Rating
10. The Command Source
11. The Frequency Command Source
Click Finish to load the settings of the Startup Wizard into the ASD. Application-specific
programming may then be required. See the section titled
additional information on the Startup Wizard.

Operation (Local)

Note: See F003
To turn the motor on, perform the following:
1. Press the MODE key until the Frequency
Command screen is displayed.
2. Press the HAND/AUTO key to enter the Hand mode
(green HAND/AUTO LED illuminates).
3. Turn the Rotary Encoder clockwise until the
Frequency Command value is at the desired setting.
4. Press the RUN key and the motor runs at the
Frequency Command
Note:
5. Press the STOP/RESET key to stop the motor.
38
69). See the section titled
for information on Auto operation.
value.
The speed of the motor may be changed while the motor is running by using the
Rotary Encoder to change the Frequency Command value.
Default Setting Changes on pg. 39
(if Yes, continue from step 8)
Startup Wizard Requirements on pg. 66
Frequency Command Screen.
Frequency Command
WX9 ASD Installation and Operation Manual
Direct
for
screen)
for